240727_M.B.

A print based on tattoo designs I once made for someone (M.B.). Used tetra from a large roll intended for floor protection. It’s very sturdy but a bit of a downside is that the shiny surface isn’t as shiny as that from actual tetra packaging. That means it repels the ink much less so you get an ink buildup. So for best results I have to wipe off the ink after about every 2 prints. It works much better with oil based inks instead of the waterbased ink used here (which I found out later). Print size is 12x12 cm on 20x20 cm offwhite paper.